Washer repair

5 Troubleshooting Steps Before Calling for Washer Repair

Washer repair in San Antonio does not have to be hard.

Washer repair

5 Troubleshooting Steps Before Calling for Washer Repairs
Washer repair

The washing machine is by far one of the most useful appliances in the house, though few of us know what it’s like to wash and dry our own clothes without the help of a self-agitating drum. Having clean clothes is an important part of a healthy, comfortable life so when your washing machine starts acting up, it’s something worth being concerned about. However, not every malfunction is caused by an actual problem with the machine. In many cases, you can set things right with a few simple maintenance steps and avoid washer repair in San Antonio.

1) Set the Feet Level

Any time you’re dealing with something that spins, it’s important to have an even balance. Otherwise, the spin will be thrown off and your washer will either stop working or start making a terrible clunking noise when it runs as the drum hits the outer edge of the chamber. This will surely result in the need for a washer repair from a top rated appliance pro.  Older washers are more likely to shake and make noise while newer ‘smart’ washers may simply sense that something is wrong and refuse to run. In either case, check the washer’s feet. They need to be level so that the washer stands evenly.

2) Clean the Inside Thoroughly

You run a lot of dirty clothes and detergent through your washing machine and they don’t always self-clean perfectly. If there is a lingering smell in your washer or on your clothes, you may just need to clean the inside. Hard water can  Use a gentle detergent or a hot water and vinegar mixture. If your washer is suffering from the effects of hard water, vinegar is the better choice. Wipe down the entire inside of the drum, the inside of the door, and any nooks or crannies you can reach.

3) Run It Empty Once

More often than not, if a washer has been acting up in any number of ways, running it once empty with hot water and a little vinegar can help. If the issue you’re having is one of cleanliness, running the washer empty will help it clean itself and clear the lines. If it is having water issues that persist in an empty run, it’s time to check the lines and the drain. If you’ve been having balance problems that don’t appear during the empty run, the problem may be how you’re loading the clothes.

4) Wipe Down the Rubber Seal

Just like your refrigerator, the rubber seal on your washer relies on being clean in order to close and many modern washers won’t start if the seal isn’t closed. If you’re having leaking problems or your washer won’t start, use a warm water and vinegar solution to break up any residual detergent and remove any grime or hair that has built up. Don’t be shy about using folded paper towels or q-tips to get into hard to reach crevices.

5) Clear Drain Pump Filter

Your washer relies on water flowing freely both in and out of the appliance. While your faucet should continue working reliably in most cases, the drain may become clogged with all the usual lint and hair. If you’re having drainage issues. check your drain pump filter and clean it out on a fairly regular basis. The drain can usually be found on the front bottom of the appliance behind a small panel.

Your washing machine is a complex mechanism but there are plenty of things you can do to maintain it at home. However, if you’ve tried cleaning it, leveling the feet, and checking on the fill and drain routes and the problem persists, it’s time to call a professional. For more helpful washer repair tips or to schedule a repair service, contact us today!

Also check us out on Google Plus or Facebook

SoBellas Appliance Repair San Antonio Texas

21019 US Hwy 281 N Ste 830-23

San Antonio, TX  78258

210-978-0890

Posted in Appliance and tagged , .